GSM Commander

Automation or automatic control is the combination of different technological devices. Switching devices of various control systems remotely on and off via Smart phone, PC or Tablet.  This can be used for operating equipment such as machinery, processes in factories, boilers and heat treating ovens, controlling pumps or water irrigation systems to name a few.

The biggest benefit of automation is that it saves labour; however, it is also used to save energy and materials as well as to improve quality, accuracy and precision.

With our new added value product GSM Commander that is a fully programmable intelligent device that goes beyond mere monitoring of a remote site. It can be programmed to control and manage your equipment directly, without the need for additional timers or logic controllers. Instead of only monitoring temperature, we can control it too: Switching a pump via SMS? We can do that automatically via built-in timers functions, and at the same time check the pressure and flow-rates, and make intelligent decisions! Easy to figure out and well priced, it is a tool to unleash your creativity, helping us to create solutions that saves time and makes money for you the farmer.

With the GSM Commander we can also control and monitor you Pump & Pivot control with monitoring & Cable Theft Prevention on the Cable theft monitor unit.

Cable Theft Monitor

One of the biggest challenges in the fight against cable theft is the protection of cables that are not powered. One great example of this is a pump that is not powered, then often the cable is stolen, with expensive results..

The Cable Theft Monitor (CTM) module allows you to monitor “live” or “dead” cables and provides a contact output to signal when anything goes wrong. It can easily be connected to our GSM Commander product (or any other device) to notify you remotely of any eventmon the cable. It is able to monitor both 3phase and single phase cable runs.

Product Highlights

• Monitors 3phase and single phase cables.
• Contact Output to signal fault
• Contact remains closed as long as fault is present
• Operates from 12V

How does it work?

The CTM injects a special DC signal into the cable, and verifies that it is reflected at the far end of the cable. If the signal is not reflected, the CTM will detect this and activate the output contacts. The contacts will remain closed for as long as the fault condition exists.

Airdrive

Airdrive Subscriptions

 

Model Dependency: * Features are Model Dependant for only GC0641 and GC1281 GSM Commander Models.